Union Spring Main: Spring machine, Wire rotary spring machine, Wire bending machine

Union Spring(Shenzhen) Technology Co., Ltd.

Home > News > Company News

How to check the failure of metal wire forming machine

A long period of operation of the wire forming machine requires a series of inspections. For example, after a fault occurs, we also need to know how to check the failure of the metal wire forming machine. Let ’s take a look at the following.

1. Look around the work site and remove-cut debris that obstructs work and traffic. There must be no oil on the ground to avoid slipping. Work pieces should be stacked neatly and firmly to prevent injury from falling.

2. Check whether the protective device on the wire forming machine is intact. If it is not installed, you are not allowed to drive. The intermediate frequency pipe bender should have good grounding and electrical insulation, and the voltage should be stable.

3. Check the smooth part of the wire forming machine. When the oil is lacking and oil is not enough, the oil should be fully added.

4. During the trial run of the empty car, check whether the machinery is operating normally and whether the electrical switch is active and easy to use. After everything is normal, do the work again.

5. When two people work at the same time, they should cooperate closely and coordinate. Designate someone to operate the switch. Do not talk or laugh with others during operation to prevent malfunction.

6. When the machine is started, the operator must not leave the machine.

7. When the wire forming machine is in operation, no one is allowed in the vicinity of the tube's bending stroke, and a protective warning sign is established. Stand firmly when prying the pipe to avoid being injured by skids. The operator can only stand outside.

metal wire forming machine

After long-term operation of the metal wire forming machine, the components will age and the performance will deteriorate. When they are not completely damaged, the failures will sometimes disappear, which is normal. So we need to find out its fault and repair the wire forming machine in time.

The above is how to view all the problems of the metal wire forming machine failure. For more information, please pay attention to this site.